Gloves are available in sizes M (8), L (9-10), and XL (11). The numerical values correspond to the circumference of the hand, measured in inches.

Measure the outer diameter of the glove port. To ensure the system’s tightness, choose gloves with a cuff diameter slightly smaller than the port diameter in the glovebox/isolator.
Available glove cuff diameters:
6 inches – 152 mm

7 inches – 178 mm

8 inches – 203 mm

9 inches – 229 mm

10 inches – 254 mm

12 inches – 305 mm

If you are not sure which gloves to choose, we are happy to help!

Ambidextrous gloves are universal and have the same, symmetrical hand shape. They are versatile in use – each glove can be worn on either the left or right port. Anatomical gloves, on the other hand, are more tailored to the natural shape of the hand, with the thumb positioned inward relative to the other fingers. Therefore, we distinguish right and left gloves.

Gloves should be stored in their original packaging to protect them from dirt, in a dry place, at room temperature, away from direct sunlight or heat sources. Gloves should not be stacked or stored under heavy objects to prevent creases from forming.

A good laboratory practice, especially when multiple users are working in the glovebox, is to wear disposable powder-free or cotton gloves underneath the main glovebox gloves.
If the gloves become contaminated, you can wipe them with a cloth or gently wash them with water, avoiding strong detergents. It is important not to expose the gloves to mechanical damage, such as scrubbing or friction. They should be thoroughly dried before reuse. If the gloves have been severely contaminated or came into contact with hazardous substances, it is best to replace them. In some cases (with models made of EPDM), autoclave sterilization can be considered.

Yes, we offer gloves made of EPDM (Ethylene-Propylene-Diene-Rubber), which can be steam sterilized at 121°C in an autoclave.

Gloves are classified as consumable components, and the frequency of their replacement depends on several factors. According to general recommendations, preventive replacement of gloves is advised no less than every 6–10 months, even if a visual inspection does not indicate visible damage. A visual inspection of the gloves should be performed daily before starting work, and if even minor defects are detected, they should be replaced. Remember, gloves may affect your safety or the success of your experiments conducted in the glovebox. Regular replacement is crucial for maintaining hygiene, laboratory safety, and the protection of sensitive materials. It is also important to have a spare pair to ensure continuity of work in case the gloves are accidentally damaged.

Safe glove replacement is possible thanks to a specially designed cover that seals the glove port during the replacement process. With this cover, you don’t have to worry about compromising the cleanliness of the working atmosphere or the release of hazardous materials into the environment. More information about this solution can be found in the Accessories section.

Gloves from the GSE (EPDM) and the GSB (butyl) series comply with the FDA 21 CFR 177.2600 regulation issued by the U.S. Food and Drug Administration and can be used in contact with food/medications.